Need help getting started with Delta 1010LT

[Sandcassle]

Hello to all of my fellow musicians in this forum. I'm new to DAW recording and need a little help getting started.

I purchased Adobe Audition 2.0 and a Delta 1010LT audio card. All I want to do at this time is just lay down some basic tracks. That’s all.
I mostly want to record acoustic & electric guitar, digital keyboard and vocals. I have a Rode NTK tube mike and SM 57’s/58’s.
I have the Audition 2.0 loaded on my computer, but yet have I installed the Delta 1010LT card. The user's guide says I need to make sure I have the jumper switches configured properly before I install the card.
Can someone help me get this sound card installed and connected correctly?
Thanks in advance!

Roy

[brandondrury]

Can someone help me get this sound card installed and connected correctly?

Yes.

So what's the problem? Please be specific.

Brandon

[Sandcassle]

I've sinced figured it out, but I was wanting to know what settings the jumpers in the 1010LT need to be set at for the xlr analog inputs 1 & 2.

I set them at line level since I'm using my mackie mixer preamps anyway.

I have a 24 channel Mackie board, so I've connected the 1010LT inputs to the Line Outs, tip "send" only. I use the preamp trim pots for record level control.
Seems to work out ok.

Thanks!

[brandondrury]

I've sinced figured it out, but I was wanting to know what settings the jumpers in the 1010LT need to be set at for the xlr analog inputs 1 & 2.

You've got me! I'm guessing this would be in the manual.

I have a 24 channel Mackie board, so I've connected the 1010LT inputs to the Line Outs, tip "send" only. I use the preamp trim pots for record level control.
Seems to work out ok.

Yup. I did it that way for years.

Brandon